General Touch ST6001U (SAW) Touch controller .

Hi All I have for sale 51 x ST6001U SAW Controllers. They will be supplied with only 33 USB cable kits. Compatible with General Touch SAW sensors and ELO SAW Sensors (Sensors not supplied) Features ST6001S is the newest controller supplied by General touch. · 6.6/10.4ms conversion time · Support size of touchscreens from 6.4’ to 22’ without jumper setting · Touch sensitivity can be adjusted in 5 levels · T mode and C mode data transmit Protocols · Operation temperature from -20°C to 70°C Reliability MTBF is more than 300,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 25. Interface EIA 232E (Serial RS-232). DCE configuration, 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex. Baud Rate 9600 Operation Mode Support T and C Mode Protocols (only ST6001S-H) Support UP/STREAM/DOWN and Z Axis Modes Touch Resolution 4096x4096, size independent, 256 levels of Z axis (pressure) Supply Voltage and Current +12VDCnormal (+9V to +15Vdc) 86mA, typical at +12VDC, Average power consumption is 1.0W, typical. Supply must be capable of sourcing 200mA, minimum. Total noise and ripple requirement must be less than 100mV (p-p) for frequencies below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz. Sensors can be purchased from: www.generaltouch.com 20.00 Per controller (Cables Free)